This seminar provides insights into the value of injection molding
simulation, in relation to the manufacturing process. Advances in material testing
measurement techniques are presented and then explored in the Autodesk Material
Testing Laboratory.
The presentations will be followed by a networking session with finger food and drinks.
Date/Time: Tuesday, 10th September 2019, 5:00 to 8:30 pm.
Venue: Autodesk, 259-261 Colchester Rd, Kilsyth South VIC 3137
This AGM program is as follows:
4:30 pm to 5:00 pm
Registration (held in Autodesk reception)
5:00 pm to 5:05 pm
Welcome
Dr Muthu Pannirselvam, SPE:ANZ
5:05 pm to 5:25 pm
Injection Molding Insights
Speaker: Dr. Franco Costa
Note: This presentation explores physical insights of the injection molding manufacturing
process. Results are presented from research covering Injection Overmolding of Stamp
Formed Composites project.
5:25 pm to 5:45 pm
Advances in Material Testing Measurement Technology
Speaker: Dr. Russell Speight
Note: This presentation provides a broad overview of the material testing requirements for
Injection Molding Simulation, and then explores advances in thermal conductivity
measurement.
5:45 pm to 6:45 pm
Autodesk Material Testing Laboratory Tour
Note: Material testing for plastics is continually advancing. During this tour you will
understand the materials data requirements for Moldflow Injection Molding Simulation,
to ensure the best results. The latest test methods will be discussed. (depending on
numbers, we will sub-divide in separate groups).
6:45 pm to 7:30 pm
Break for Drinks and Nibbles
7:30 pm to 8:25 pm
Annual General Meeting
8.25pm to 8.30 pm
Closing Remarks
Russell Speight, SPE:ANZ Section
Safety Note:
All attendees that are wanting to participate in the lab tour must wear a full cover shoes on your arrival. Safety glasses will be provided.
For further information contact Muthu Pannirselvam on 0451902123
Comments